Tandberg Data Magnum 448, Руководство пользователя

Страница: 8 / 16

8
OF
16
a. Remove the two screws (
A
) holding the tape drive cooling plate (
B
). Remove the plate, and discard it and
the screws.
b. Disconnect the power cables as needed.
Rev “A” power supply installed (no Rev B label)—disconnect all cables.
Rev “B” power supply installed—disconnect from
only
the tape drive you are replacing.
3. Installing the tape drive—
a. Locate the serial cable that came in your replacement kit and attach it to the appropriate serial connector
inside the library.
Library serial cable connections—
b. While holding the cables to the side, slide the new tape drive directly into the library, leaving it a short
distance out to access the cables. Use care not to damage the cables.
c. Connect the supplied serial cable and the power cable to the tape drives.
Figure 9 Tape drive cooling plate
!
Important
Do not mix full height and half height -or- SCSI and Fibre Channel tape drives in the
Magnum 448 library, as it does not support mixed tape drive configurations.
Tape drive Quantity
Install in this
opening...
Serial
connector
Internal
label
Internal serial
connector location
Full height
Second tape drive Top Second Drive 2
Figure 1 on page 3
Single tape drive Bottom Bottom Drive 1
Half height
Fourth tape drive Top Top Drive 4
Third tape drive Third Third Drive 3
Second tape drive Second Second Drive 2
Single tape drive Bottom Bottom Drive 1
Cooling plate
(
B
)
Looking inside back of library
Screws (
A
)