Tandberg Data Magnum 448, Руководство пользователя

Страница: 11 / 16

11
OF
16
R
EPLACING A
T
APE
D
RIVE
(
SAME CONFIGURATION
)
To replace a tape drive with a different tape drive of the same configuration (half height to half height, or full
height to full height), follow these steps.
1.
Preparing for replacement—
a. Update library firmware to v. V1D181 or higher (see Important note above).
b. Power off the host.
c. Power off the library (press the 0 on the back of the unit).
d. Disconnect the power cord, the SCSI or Fibre Channel cable(s), and the terminator (if present).
e. Remove the tape drive cover plate. Set the plate and the screws aside.
Library
If your library has... Attach this SCSI cover plate...
Tape drive configuration Quantity Location External drive label
Magnum448
Full height
Two None None
One Top Drive 2
a
Half height
Four None None
Three Top Drive 4
Two Top and third Drive 4 and 3
One Top three Drive 4, 3, and 2
a
This applies to both SCSI and Fibre Channel library configurations.
!
Important
You must update your Magnum 448 library to the current firmware (v. V1D181 or
higher) before you install your new drive. The firmware allows the library to
auto-configure the tape drive installation upon power up, eliminating the step of
manually configuring the library after tape drive installation.
If your library code is not updated to v. V1D181 or higher, you will need to contact
Tandberg Data technical support for manual configuration instructions.
Figure 14 Tape drive cover plate (FH SCSI library)
Power OFF (press the
0
)
Disconnect power cord
Tape drive cover plate
Back of library
Screws
(4 each side)