Tandberg Data BAKSTOR, Руководство администратора

Страница: 17 / 67

Tandberg Data
BakStor Installation and Administration Manual 15
2.3.2 Ethernet 0
Connect the BakStor to the existing LAN by plugging an Ethernet cable to position F. Figure
2-5)
The Ethernet connection can be a 10/100/1000 Mbps to match capabilities of the connecting
LAN.
2.3.3 Ethernet 5
The BakStor also has the ability to manage Fault Tolerance and Load Balancing technology by
using two Ethernet connections.
In order to use Fault Tolerance or Load Balancing a secondary Ethernet cable is required. The
second cable is connected to position G. (Figure 2-6)
A second Ethernet connection is not required unless Fault Tolerance and / or Load Balancing is
needed. The second Ethernet connection is not required for the initial setup.
2.3.4 Ethernet 1 - 4
The four Ethernet connections labeled M, N, O and P (Figure 2-7) are to be used for connecting
BakStor 2000EX expansion units. Do not connect these four Ethernet connections to a LAN.
2.4 Mounting the BakStor
When mounting the BakStor ensure that the unit is oriented correctly.
When viewing a BakStor unit from the front correct orientation is ensured when:
The blue LED on each disk caddie is located on the RIGHT side of the caddie.
On a BakStor 1000 the powerbutton and reset button are located ABOVE the disk caddies.
On a BakStor 2000 the powerbutton is located in the LOW and LEFT corner of the front panel.
When viewing a BakStor unit from the rear correct orientation is ensured when:
The power connectors are located on the LEFT side of the unit
The external SCSI controller is located on the RIGHT side of the unit
The BakStor is designed to operate in a position where it is lying flat.
CAUTION!
DO NOT OPERATE A BAKSTOR MOUNTED IN A SIDEWAYS OR UPSIDE DOWN
POSITION.