Tandberg Data BAKSTOR, Руководство администратора

Страница: 16 / 67

Tandberg Data
14 BakStor Installation and Administration Manual
2.2.1 Power
Connect a single 3-pin 100/240V AC power cable to position J. (Figure 2-1)
2.2.2 Ethernet 0
Connect the BakStor to the existing LAN by plugging an Ethernet cable to position F. (Figure
2-1)
The Ethernet connection can be a 10/100/1000 Mbps to match capabilities of the connecting
LAN.
2.2.3 Ethernet 1
The BakStor also has the ability to manage Fault Tolerance and Load Balancing technology by
using two Ethernet connections.
In order to use Fault Tolerance or Load Balancing a secondary Ethernet cable is required. The
second cable is connected to position G. (Figure 2-1)
A second Ethernet connection is not required unless Fault Tolerance and Load Balancing is
needed. The second Ethernet connection is not required for the initial setup.
2.3 Connectors on the BakStor 2000 (2U-Unit)
Figure 2-2 Connectors on the BakStor 2000
Function Connector Function Connector
Power J1 and J2 External tape device 1 K1
Ethernet 0 F External tape device 2 K2
Ethernet 1 P Power Alarm reset L
Ethernet 2 O
Ethernet 3 N
Ethernet 4 M
Ethernet 5 G
2.3.1 Power
Connect the two 3-pin 100/240V AC power cable to positions J1 and J2. (Figure 2-3)
Note that the power supplies are redundant; if one should fail the BakStor will still be able to
operate. In the case of a power supply failure an alarm will bet set off. The alarm can be reset by
pushing button L. (Figure 2-4)
J1
J2
L
P O N M
K2 K1
G F