tams elektronik KSM-4, Руководство пользователя

Страница: 11 / 20

t a ms elektronik KSM-4
4. Operation
LED displays
There are two LEDs (red and green) on the PCB, showing significant operating states:
red LED green LED
Standard
operation on → showing the points´
switching time on → position of points 1
off → position of points 2
Setting the
adress fast flashing → KSM-4 in
programming mode
After having programmed the new address, both LEDs flash together
several times and remain switched on until the points are switched for
the next time.
Setting the
switching time
for points on → showing the points´
switching time fast flashing
→ KSM-4 in setting mode
Points address
In state of delivery the points react to address 100. In order to change the address, proceed
as follows:
1. Switch on the voltage supply ("go"). Push both push-buttons simultaneuously. The green
LED flashes, the KSM-4 is in programming mode.
2. Enter the desired address at you digital central unit and perform a switching command for
this address.
3. The programming mode is terminated automatically. Both LEDs flash together several
times and remain switched on until the points are switched for the next time.
Setting the switching time for the points
In state of delivery the switching time for the points is set to 500 ms. In order to change the
switching time, proceed as follows:
1. Switch off the voltage supply ("stop"). Switch on the voltage supply ("go") again and while
doing so, keep both push-buttons pushed simultaneuously. The green LED flashes, the red
one shows the points´ switching time.
2. Then, push the push-buttons to alter the switching time; push-button 1 to decrease the
switching time, push-button 2 to increase the switching time. The red LED always shows
the set switching time. Before altering the switching time again, you have to wait for the
red LED to go out.
3. In order to finish the setting of the switching time, switch off the voltage supply again
("stop").
Operation | 11