ENGINE CONTROL
This is mounted at the top left side of the handle (most models). It operates the choke, for starting,
and allows you to set the governed speed of the engine while cutting or to stop the engine.
You will not need to change the control setting constantly while mowing because the governor holds
the selected speed, even under varying cutting loads. The positions for START, FAST, SLOW and
STOP are marked.
Fig. 6
Fig. 7
AU
10
RUNNING THE ENGINE
Ensure that the engine has been prepared correctly and that the fuel tap is turned ON. We
recommend that you check the oil level before every mowing session.
COLD STARTING-AM3030N/AM3034N
1. Set the engine control to the START position.
2. Turn the fuel tap to the “ON” position. (Fig. 8)
3. Push the primer bulb 3 times.
4. Stand to the right of the mower. Hold the top handle firmly with your left hand to hold mower
stationary. Grasp the starter rope handle and pull slowly until resistance is felt. Then pull briskly.
5. If engine fails to start and run after three pulls press primer bulb again once only. Pull Starter rope
as per point 4.
Do not pull the starter rope with a jerk or release it until fully rewound.
6. When engine has warmed up for a short time move the engine control lever to the desired speed
position for cutting.
Fuel
tap
Primer
bulb
Fig. 8
AU
11
WARNING
Never run the engine indoors or in poorly ventilated areas. engine exhaust
contains carbon monoxide, an odourless and deadly gas. keep hands, feet, hair
and loose clothing away from moving parts.
STARTING THE ENGINE
