Tally Dascom DT-210, Руководство программиста

Страница: 55 / 57

Tally Dascom DT-210/230 Programming Guide V1.1
- 50 -
ESC c 3 n
[Type] Paper sensor
[Function] Select paper sensor(s) to output paper-end signals
[Format] ASCII ESC c 3 n
Hex 1B 63 33 n
Decimal 27 99 51 n
[Range]
0 ≤ n ≤ 255
[Default]
n = 0 [when DIP switch [SW 1-3] is on.]
n = 15 [when DIP switch [SW 1-3] is off.]
[Description]
Select whether the paper sensor(s) to output paper end signals or not when a paper end
is detected.
(n)Bit Off/On Hex Decimal Function
0 Off 00 0 Disables roll paper near-end sensor.
On 01 1 Enables roll paper near-end sensor.
1 Off 00 0 Disables roll paper near-end sensor.
On 02 2 Enables roll paper near-end sensor.
2 Off 00 00 Disables roll paper end sensor (paper sensor).
On 04 4 Enables roll paper end sensor (paper sensor).
3 Off 00 00 Disables roll paper end sensor (paper sensor).
On 08 8 Enables roll paper end sensor (paper sensor).
4-7 Off 00 0 Reserved.
[Note] This command is enabled only with a parallel interface model.
ESC c 4 n
[Type] Paper sensor
[Function] Selecting paper sensor to stop printing
[Format] ASCII ESC c 4 n
Hex 1B 63 34 n
Decimal 27 99 52 n
[Range]
0 ≤ n ≤ 255
[Default]
n = 0
[Description]
Select the paper sensor(s) whether to use to stop printing or not when a paper end is
detected.
(n)Bit Off/On Hex Decimal Function
0 Off 00 0 Roll paper near-end sensor disabled
On 01 1 Roll paper near-end sensor enabled.
1 Off 00 0 Roll paper near-end sensor disabled
On 02 2 Roll paper near-end sensor enabled.
2-7 Off 00 0 Reserved.