ETP-500
Series Analog Call Station
Installation & Operation Manual
Page
6
of
23
Rev. 3/16/2017
Copyright 2017 Talkaphone
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talkaphone All rights reserved.
To begin programming, call the Talkaphone unit. Enter the factory set Guard Access Code, *4**. You
are now able to program the features described below.
Access Codes
This unit offers two levels of software security, each with its own password. The Guard Access security
level allows authorized personnel to program the phone and use operational codes. The Master
Access security level allows the system administrator to change the Guard Access and Master Access
Codes, thereby prohibiting unauthorized system access.
If you lose the Master Access Code, you will have no way of changing the Guard Access Code other
than a hardware reset of the unit, which reverts ALL programming to original factory settings (For
instructions see FAQ, p.15).
Command
Function
*3* …[up to 8 digits]*
Master Access Code entry to change Guard Access Code or Master
Access Code
(Default Code is *3*12345678*)
*4* …[up to 8 digits]*
Guard Access Code entry for phone programming
(Default Code is *4**)
*10* …[up to 8 digits]*
Programs and stores a new Master Access Code
*11* …[up to 8 digits]*
Programs and stores a new Guard Access Code
*75*
Allow the performance of Operation Codes *25*, *26*, *28*, *29* and
6 WITHOUT the Guard Access Code
—
See Operation Codes, p.9.
*76*
REQUIRES the Guard Access Code to perform Operation Codes
*25*, *26*, *28*, *29*, and 6
—
See Operation Codes, p.9.
(default)
Primary & Secondary Phone Number Codes
You must program a primary phone number for the unit to function correctly. You may also program a
secondary phone number. If the first number is busy or does not answer after a specified number of
rings (see PBX/Timing Configuration Codes, p.9), the phone will hang up and try again, this time using
the second phone number if one is programmed, or the first number if no second phone number exists.
It will retry these numbers until the call is answered or the conversation time elapses (see PBX/Timing
Configuration Codes, p.9).
Command
Function
*13*
…[up to 18 digits]*
Programs the primary number called by Button #1
*23* …[up to 18 digits]*
Programs the secondary number called by Button #1
*80* …[up to 18 digits]*
Programs the primary number called by Button #2
*81* …[up to 18 digits]*
Programs the secondary number called by Button #2
If your phone has two buttons, the top button is Button #1 and the bottom button is Button #2. If you
have a Keypad phone, Button #2
cannot
be programmed to dial an outside number. This button is
used to get a dial tone before using the keypad to dial.
Entering "#" inserts a four second pause when placed in a dial string.
For example:
When using 9 to obtain an outside line, enter "9#" and then the number desired. This allows the
phone system to switch to an outside line without missing dialed digits.
When dialing pagers or voicemail systems, use "#" in the number string where a pause is required.
