ETP-120
Series Phone
Installation & Operation Manual
Page
4
of
27
Rev. 7/2/2021
Copyright 2021 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
2. Hardware Installation
Installation should be performed by qualified personnel only in accordance with the National Electrical
Code and other federal, state and local statutes and building codes. Using shielded cable is
recommended to avoid noise, hum, and other
operational
anomalies.
You will need a TS-10 Pin-in-Torx screwdriver or bit to complete this. If you do not own one, you may
purchase one from your local industrial supply store or from Talkaphone. Contact your Talkaphone
distributor for purchasing information.
Talkaphone Model
FM-110
and Model
SM-110
are designed to accommodate the ETP-120 Series
Analog Call Stations for flush mounting and surface mounting, respectively. Contact your distributor or
Talkaphone for more information.
1. Plug the RJ11 connector on the cable assembly into an RJ11 receptacle that is terminated to an
analog phone line (red is ring, green is tip). The RJ11 connector is terminated on a cable harness
that routes back to a small 2-pin connector located near center-right on the circuit board (see photo
below).
