Disposal
Version 1.0
Linear transfer system LFA
37 / 39
9
Disposal
Required personal protective equipment
DANGER
Electric shock
Touching live parts poses an immediate danger to life
•
Work on electrical systems may only be carried out by qualified electricians
•
Before starting work, disconnect the system, secure it against being switched on again and
make sure that no voltage is present
NOTICE
Environmental damage
Improper disposal may result in environmental damage
•
Dispose of components and operating materials in accordance with local regulations
•
Observe the safety data sheets of the operating materials
Materials used
The components are mainly made of the following materials:
•
Copper (complete drive units, electrical cables)
•
Steel and grey cast iron (housings, attachments, shafts, bearings)
•
Plastic (toothed belts, insulation, bearings)
Preparation for disposal
1. Disconnect the system from all power supplies and secure it against being switched on again.
2. Wait 15 minutes until all live components are completely discharged.
3. Disassemble and dispose of assemblies and components in accordance with local environmental regulations.
Assembly instruction
s
