Care must be taken when rotating the chair
When rotating the chair, make sure to confirm that nobody is around the chair. If the chair hits someone (especially
around the steps), it may result in injury.
Safety Precautions (Be sure to observe the instructions)
Be careful during headrest operation
Do NOT pound, scrape or swing the equipment
Doing so may lead to the destruction or malfunction of the cover or other such parts.
Caution
Notes for Use
Be careful when reclining or raising the backrest
When reclining or raising the backrest, take sufficient care to ensure that customers’ fingers or other objects are not
between the backrest and the seat. Not doing so may result in bodily injury from pinching or other such accidents.
When operating the chair, mind the surrounding area
Sit only on or around the center of the seat
Never sit on the headrest, backrest, step, armrest, or on the front edge of the seat when the backrest has been reclined.
Also, do not apply more weight to the chair than necessary. Doing so may cause the chair to fall over or break.
Do NOT apply excessive weight to any part of the chair
Be careful during installation
When moving the chair, make sure to hold the following locations
To transport the chair, hold the base plate and the up/down foot pedals. Do not lift up the chair by holding the upper
seat unit only. Otherwise, the base unit may fall off and cause serious injury.
Warning
2
· Please be careful, as the headrest will come off when pulled up too high. Also, when operating the headrest, take care
to not have your fingers pinched around the headrest area or between the backrest.
· When you pull out the headrest, be sure to ensure that the headrest do not hit the customer’s head.
Before or during operation of the chair, sufficient care must be taken to ensure that bodies, hands and feet, or obstructions are not around the
operating range (raise/lower direction of the chair, recline/raise direction of the backrest, in/out direction of the legrest, and the rotation
direction of the chair). If care is not taken to do so, it may result in being pinched by the chair, and may cause bodily harm or property damage.
Do not sit on the legrest or backrest. Also, do not apply more than the necessary weight to the chair. Doing so may
cause the chair to fall over or break. The legrest and backrest can withstand a load of 600N (60 kgf/132 lbf). Do not apply
more than the necessary weight to the headrest or armrest. The headrest can withstand a load of 100N (10 kgf/22 lbf).
· Have installation or mounting of the equipment performed by a professional (from TAKARA BELMONT or a TAKARA
BELMONT specified representative).
· The chair must be installed on flat and solid flooring. If the chair is used on an area where the flooring surface is
inclined at 5° or more, it may cause the chair to fall over.
Care must be taken with customers and children
Be sure to ensure that customers, especially children, do not touch the operating parts. Failure to do so may cause an accident.
