TAJIMA TFMX-IIC, Руководство пользователя

Страница: 131 / 268

To increase embroidering efficiency
117
Chapter 5
1
2
3
4
5
6
7
8
9
10
11
8.
To increase embroidering efficiency
8-1. To change number of lowering needle bar at slow operation (Main Shaft Inching)
This function targets slow operation when the machine stops in the middle of embroidery and then the
machine restarts. Regarding the number of lowering the needle bar by slow operation at start after thread
trimming or after data set, refer to the detail page.(
→ p.80)
8-1-1. Screen
8-1-2. How to operate
The following is an example that the number of Start Inching is set to "3".
(1)
To open screen
(2) To select number of lowering needle bar at slow operation
8-2.
To collect up frame moving amount of consecutive jump stitches in a batch to feed the
frame all at once (Jump code combination)
This function reduces the number of stitches by combining frame moving amount of consecutive jump
stitches (up to 5 stitches) and by feeding the frame all at once.
8-2-1. Screen
Number of lowering needle bar at slow
operation
YES: To set
NO: Not to set
3 Main Shaft Inching
4
)
3 Main Shaft Inching 4
3
6(7 6(7
5 Jump Code Combination
NO