TAJIMA TCMX 601, Руководство пользователя, Страница: 92 / 130

Parameter (embroidery, head)
10-3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
3.
Thread management after thread
trimming
This setting selects whether cut end of thread after thread trimming is
pulled out onto the fabric or not to prevent fray of thread.
1.
To call the screen......................................................
2.
To set ................................................................. End
Switching the screen
Main screen.....................
Other setting • operation .
4.
The number of tie stitches
Set the number of tie stitches (chain stitches) to prevent fray of thread.
1.
To call the screen......................................................
2.
To set ................................................................. End
Switching the screen
Main screen.....................
Other setting • operation .
This setting is effective only at color change accompanied
with design interval movement such as jump or at end of
embroidery. It is invalid at color change without design inter-
val movement (the next stitch is generated by remaining cut
end of thread and thread to start to sew after color change).
F5
List screen List screen
7 Thread Management After Trimming (CM)
or
Press ?
F5
Down
Setting range
Down: To push thread under the fabric
Up1: To pull thread on the fabric
Up2: To pull thread on the fabric and take off thread
from the needle
Example: to pull out thread onto the fabric
Down Up1
E
A D2 F1 F6
Tie stitching is performed only at thread trimming of loop
stitch.
In case of manual thread trimming, tie stitching will not be
performed.
In the middle of embroidery, it is not possible to set the num-
ber of stitches exceeding the remaining number of stitches
from the position to thread trimming position.
F5
List screen List screen
6 The Number of Tie Stitches (CM)
or
Press ?
F5
NO
Setting range: 0 (not to perform), 1 to 9
Example: 3 (times)
NO 3
E
A D2 F1 F6
JZ07