TAJIMA TCMX 601, Руководство пользователя

Страница: 110 / 130

Troubleshooting
13-3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
2C1
The machine was started without setting of automatic stitch
type selection.
Perform automatic stitch type selection.
2C2 Setting for option is incorrect. Set correctly.
2C6
(*)
Machine operation was attempted although the bobbin
changer was running.
Do not operate the machine during working of the bobbin
changer.
* Only the model that is equipped with bobbin changer
2C7 Wrong password was input. Input the correct password after pressing the reset key ( ).
2C8 Sleep mode key was pressed during trace. Press the reset key ( ).
2CA The power is not turned “OFF/ON”. Turn “OFF/ON” the power.
2CE
Stop by safety device
After removing an obstacle, press the reset key
( ) and
then
press the start switch.
2E2
Air pressure of the regulator has become lower than the
rated value.
Check the air compressor. Check the origin of air supply.
2E3
Power was shut off during operation of embroidery.
Perform operation of power resume after turning ON the
power.
311
Encoder A signal does not change for 5 seconds.
Check the encoder or encoder signal lines.
Check the main shaft driver for excitation.
Abnormality of motor, motor belt Check the motor or motor belt.
312 Encoder Z signal status does not change. Check the encoder or encoder signal lines.
316 Abnormality of main shaft driver
Turn “OFF/ON” the power. Or switch from sleep mode to
normal mode (each driver setting will be reset). When it is
not possible to recover from the trouble, replace the card.
322 Abnormality of X-axis driver
323 Abnormality of Y-axis driver
32A The machine cannot memorize excitation of X-axis driver. • Turn “OFF/ON” the power.
• Check connection of motor of each frame driver and
sensor wire.
• Replace the corresponding frame driver.
• Replace the corresponding frame motor.
32B
The machine cannot memorize excitation of Y-axis driver.
331
Bobbin changer error
Operate the bobbin changer manually to check the place
where movements are bad, and adjust it.
382
The needle position signal status during color change does
not change for 1 second and more.
Check the color change motor and power supply circuit.
Check the potentiometer (needle position sensor).
383 Bad control of D-axis drive motor Turn “OFF/ON” the power. When the machine is not
restored even after that, replace the head card of the
corresponding CM head.
384 Bad control of the motor for looper shaft drive.
385 Z-axis malfunction
Adjust the position of the Z-axis of the corresponding CM
head.
387 Color change motor sensor error
Check the connection of the color change motor sensor
(CN7) on the machine card.
3A6 ATH knife retractable position has become nonuniform. Check the position of ATH movable knife.
3B5 Communication error
• Turn “OFF/ON” the power.
• Install the software again.
• Check the connection of CPU card
USB
hub machine card, main shaft driver and/or X/Y-axis
driver.
3C1
Contact error of the bar switch or start/stop switch,
breakage of the switch harness, or bad connection of the
connector
Check the connector and the connecting terminal.
Replace the limit switch or switch assembly.
3D6
There is abnormality in the program or in the CPU card. Check the CPU card.
Software is not installed correctly. Install software.
3F1 Tension release error (thread tension control error)
Turn “OFF/ON” the power. When the machine is not
restored even after that, adjust/replace the tension release
potentiometer.
JZ07