Tait TB9100, Инструкция по установке и эксплуатации

Страница: 41 / 144

TB9100 Installation and Operation Manual Installation 41
© Tait Electronics Limited May 2006
1. Cut the tape securing the flaps at the top of the carton and fold them
flat against the sides
b
.
2. Rotate the carton carefully onto its side
c
and then onto its top
d
,
ensuring that none of the flaps is trapped underneath.
3. Slide the carton upwards over the foam cushions and lift it away
e
.
Remove the cushion from the bottom of the base station
f
.
4. Rotate the base station and cushion carefully over the rear of the base
station
g
so that it is the right way up with the cushion on top
h
.
Remove the cushion from the top of the base station
i
.
Disposal of
Packaging
If you do not need to keep the packaging, we recommend that you recycle
it according to your local recycling methods. The foam cushions are CFC-
and HCFC-free and may be burnt in a suitable waste-to-energy combustion
facility, or compacted in landfill.
Figure 4.2 Unpacking the TB9100 base station
b
e
g
f
h i
c d