32
M2256-000-00-051
November 2001
Example
An example of a typical configuration is: #12C401060A010000BASE8F
[ITEM3]
SDM Wait for ACK Time
Two ASCII hex characters. The maximum time that the A75 will wait for an ACK from
after an SDM was sent. After this time, if no ‘ACK’ is received, the A75 sends a
PROGRESS message with the SDM Auto ACK parameter set to ‘0’.
Range : 01 to 14h (20) in steps of 1 second. Refer to the
section.
[ITEM4]
Lead In Delay
time in Transparent mode.
Two ASCII hex characters. The Lead In Delay time of data transmission in Transpar-
ent mode is the time between the T201X radio receiving data and keying-up the
transmitter, and the A75 sending the data.
Range : 02 to FFh (255) in steps of 20 ms. Refer to the
section.
[ITEM5]
Power-up Channel
Two ASCII hex characters to represent value of the channel number selected at
power-up.
Range : 01 to 04 (for T2010), or 01 to 24 (for T2015).
[ITEM6]
Data ID
. Eight ASCII hex characters to represent the radio ID used when receiving
SDM data.
Any ASCII char is valid.
“
*
“ is the wildcard for any character. e.g. 12
**
5678. Refer to the
Receiving Short Data Messages (SDM)
section.
Message Field
Parameter
Entered at
terminal
[IDENT]
PROGRAM.
#
[SIZE]
Size of parameter field
12
[PARAMETERS]
[ITEM1] =
C4
[ITEM2] = 01; SDM ACK delay time is 100ms
(for details refer to the SEND_SDM section)
01
[ITEM3] = 06; Wait for ACK is 6 seconds
06
[ITEM4] = 0A; Transparent mode Lead in Delay is 200ms
0A
[ITEM5] = 01; the T201X powers-up into channel 1
01
[ITEM6] = 0000BASE; the ID assigned to the T201X radio is 0000BASE
0000BASE
[CHECKSUM]
Refer to the
section
8F
11 0 0 0 1 0 0 = C 4 h
Transparent Mode
1200 bps
Transparent Mode
@ Power-up
Over-air
1200 bps
SDM auto ACK
RTS disabled
Deactivate CTS
Command Mode
9600 bps
Содержание T2000-A75
Страница 2: ......
Страница 4: ......
Страница 10: ...10 M2256 000 00 051 November 2001 ...
Страница 22: ...22 M2256 000 00 051 November 2001 ...