Taiden hcs-8300, Инструкция по установке и эксплуатации

Страница: 40 / 255

27
C) Access main menu
Pressing the “MENU” button under initial user interface
will go to the main menu, which includes the following
menu items:
“Network”
“Simultaneous Interpretation”
“System Status”
“TEST”
“System Setting”
“Operation Language Setting”
“Parameters Backup/Restore”
“Machine Rename”
“About”
“About Dante”
The current chosen term (e.g. “Network”) is highlighted.

Press the “MENU” button to go to the
corresponding submenu;

Use the “

/

” button to switch from term to
term;

Use the “EXIT” button to exit current menu and
return to the upper level menu.
2.1.4.1 Network
“Network” includes three submenus:
“IP Address”
“Subnet Mask”
“Gateway”
a). Setting up unique “IP Address” for the
transmitter:
1). Select “IP Address” and press the “MENU” button
to go to setup IP address interface:
2). Use the “

/

” button to switch between the four
numbers;
3). Use the “MENU” button to edit selected number;
4). Use the “

/

” button to decrease/increase the
number. To change the number quickly (= auto
repeat) press and hold the “

/

” button for a
longer time
5). Use the “EXIT” to return to high level menu.
b). Setup “Subnet Mask” and “Gateway”
Same chronological order as for “IP Address” set up.
2.1.4.2 Simultaneous interpretation
In “Simultaneous Interpretation” submenu, the
following parameters need to be setup:

“Select Number of Channel(s):”

“Select Language For Channel:”

“Select Number of Booth(s):”

“Select Interlock Between Booths:”

“Select Interlock Mode In a Booth:”

“Select Language For Booth:”

“Auto-Relay Booth Setting”
Operation steps:
a). Setup the number of interpretation channels
Use the “

/

” button to switch between 0-63;
Note:

When controlled by PC software, “Subnet
Mask” and “Gateway” should be setup
according to the PC configuration, otherwise
it may cause a connection problem.

In menu operation, except for “Network”,
“Timing Speech Setting” and “Cobranet
Bundle Setting”, all other menu changes
should be saved via pressing “MENU”
button, pressing “EXIT” button will ignore the
changes.