Online Audio Solutions, LLC – www.tacotunes.com
RCA Input / Output
RCA Input / Output:
The ReCurve EZQ is setup with a total of 3 RCA inputs (left hand side of Recurve EZQ) and 3
RCA outputs (right hand side of ReCurve EZQ). The majority of our applications will NOT use
the RCA inputs. The RCA inputs will be covered in another user manual /stereo
configuration (JBL equipped Toyota’s). The 3 RCA outputs will be used to connect your
stereo to your aftermarket amplifier(s).
The ReCurve EZQ is labeled with Front, Rear and Subwoofer Output. You will need to run
RCA wires from your ReCurve EZQ to your new amp. Be sure to pay close attention to the
RIGHT and LEFT outputs.
Watch this video on selecting an amp for your Toyota:
www.youtube.com
Subwoofer Control Knob:
The ReCurve EZQ is equipped with a unique feature not often found in aftermarket
amplifiers. Most 5 channel & subwoofer amps offer a bass boost knob. The problem with
bass boost knob is they usually only boost the signal at around 45Hz. This leaves the rest of
the subwoofer frequency range LOWER than the 45Hz boosted frequency. The ReCurve EZQ
acts like a remote gain and will lower and raise the entire subwoofer frequency range. This
Subwoofer
Control Knob
RCA Outputs
Connect to your new amp(s)
RCA Inputs
Not used
