GS-380 / 380XL OUTRIGGER MOUNT / 3
GS-380/380XL
• Backing plates are available for extra strength and
recommended when mounting through a hardtop
(part #BP150BSY-320-1).
• When installing your Grand Slam, locate the center
of the 3-1/8" hole at least 9-1/2" from the hardtop
frame, vertical post, or any other object that might
hinder the movement of the handle.
• If the top has an arch to it, wedge plates can be
ordered to keep the Grand Slams upright and
straight (part #WP-150WHA-1).
• The maximum thickness allowable for GS-380
mounting is 2" and for GS-380XL is 4-1/2".
• The 380 and 380XL mounts are a pair of Port and
Starboard units. When installing, the Pull pin to
release the outrigger needs to face outboard for
easy access.
• When installing the handle, make sure it first goes
through the larger hole (the one that is shaped like
the opening of a doghouse) If reversed the unit will
fail to rotate.
Thank you
for purchasing the TACO Marine Grand Slam 380 or 380XL Outrigger
Mount! As a family-owned and operated business since 1959, we take pride in
offering the highest-quality, innovative products with excellent customer service.
We stand behind our products 100 percent. If you have any questions about this
mount or installation, please contact us by visiting
tacomarine.com/contactus
.
INSTALLATION
CANVAS TOP
• It is very important that your mounting surface for the Grand Slam (i.e., T-top,
Arch or Hardtop), be suitably constructed to provide a strong mounting area for
your outrigger base. It is recommended to use TACO Marine’s weld-on Grand
Slam extrusions.
• These plates are pre-drilled and ready to install the Grand Slam. If you already
have a plate, it should be at least 3/8" thick and 5" wide, with 3-4 welded seams
to be used to accommodate the 6" length of the units' base from bow to stern.
• When installing the Grand Slam through canvas, simply cut an X over the 3-1/8"
hole. Install and bolt down the Grand Slam, then trim off the excess canvas.
HARDTOP
When installing through a hardtop, verify the top is foam or core filled. It is
recommended to use included spacers (small lengths of tubing cut to size) to fit
inside where the mounting bolts pass through to ensure that when the bolts are
tightened the top is not compressed.
