TAC Xenta 555, Инструкция к добавке

Страница: 39 / 82

TAC Xenta 555, Supplement Manual 6 Setting Up MicroNet Communications Parameters
TAC AB, Oct 2006 39 (82)
04-00054-01-en
6 Setting Up MicroNet
Communications Parameters
6.1 About MicroNet Communications Parameters
All services required to send and receive data to connected MicroNet
networks are provided by a Serial Communications Interface (SCI),
which defines the communications properties for a MicroNet network.
These properties are configured during initialisation, when you initially
add a MicroNet network in XBuilder (see Chapter 5.2, “Creating a
MicroNet Project”, on page 34); these properties are read from the con-
figuration file Micronet.xml.
The properties page in XBuilder for the Micronet 1 object therefore has
the following default properties:
However, it may be necessary to change some of these parameters to
match the MicroNet network you import (see Chapter 5.3, “Creating a
MicroNet Network from an XML File”, on page 36).
Fig. 6.1:
Note
• In practice, it is usual to accept the defaults for NCP and ARC-
NET networks.
• If you are engineering a Satchnet network using IP Tunnel,
please refer to Section 11.2, “IP Tunnel and Satchnet networks”,
on page 75.