Tabletop Scenics Fantasy Bowl Stadium, Руководство по монтажу

Страница: 1 / 42

PAGE 1 / 42
Fantasy Bowl stadium
CONSTRUCTION GUIDE
Fantasy Bowl stadium
Ostrzeżenie!
Ten produkt nie jest zabawką. W opakowaniu znajdują się małe elementy nieprzeznaczone dla dzie
-
ci poniżej 14 roku życia. Części modelu zostały wycięte i wygrawerowane na płytach pilśniowych.
Nie powinno się wycinać ich z ramek wcześniej niż będą potrzebne do złożenia. Wszystkie części są
niepomalowane. Klej i farby nie stanowią części zestawu. Zawartość może się różnić od tej pokazanej
na pudełku. Do przygotowania modeli i ich złożenia rekomendujemy klej i narzędzia firmy Kromlech.
Produkt przeznaczony dla doświadczonych modelarzy.
Warning!
This product is not a toy. Package contains small parts not suitable for children under 14 years.
All parts are cut from high density fibreboard. Do not cut the parts from the frames until you are
instructed to do so. Supplied unpainted. Glue or paints not included. Contents may vary from those
shown. We recommend using Kromlech Super Glue and Kromlech Tools to prepare and assemble
HDF terrain. Our products are intended for experienced modellers and may require trimming, cutting
and fitting.
0-3
14+
WARNING!
Choking hazard!
Not suitable for
children under
36 months.
Thank you for purchasing one of our high-qualiTy producTs!
T
his guide will run you through the basic techniques and methods required to prepare, clean up and assemble HDF model.
If you have any queries or problems, don’t hesitate to
contact us
and our Support Team.
SAfety fIRSt
Tools used in preparation of a HDF model require additional attention when used. Make sure to work with good quality instruments.
Sharp blades and clippers’ cutting bit require less force to operate - when putting too much strength in cutting, the blade may break or slide
and cause serious injury. Breathing mask is recommended when using files, sandpaper, or modelling saw to avoid inhaling the dust.
KrOMleCH DOeS NOT TAKe reSPONSIBIlITy FOr IMPrOPer uSe OF TOOlS AND ACCIDeNTS DurING THe ASSeMBly PrOCeSS.
ASSeMBLING HDf StRUCtUReS
1. Before assembling your model please read through all the instructions carefully.
2. Prepare all the tools needed for the job. Modelling knife is required to safely remove the parts from the frame - do not push them out force
-
fully as they can be easily damaged.
3. remove only the parts required for the instruction step you are currently in. After the removal, it is recommended to sand the tabs and
possible roughnesses left after cutting from the frame.
4. For gluing the parts together use cyanoacrylate glue or PVA. PVA glue gives more time for altering the position of the elements, while
cyanoacrylate allows for a faster assembly. Always remember to dry fit beforehand, to check if all joints fit correctly.
5. Before painting the model, undercoat it with acrylic spray paint to protect the model from absorbing the water when using water-soluble
paints. Give it plenty time to dry. Afterwards, you can basecoat the model with your standard hobby paints.
1A 2B 1A 2B
eXPlANATION OF SyMBOlS
Made
by
Official Online Store:
bitsofwar.com
KRTS204
Made in Poland