Discovery DSC™ Getting Started Guide
Page 56
Replacing Fuses
The Discovery DSC™ contains internal fuses that are not user serviceable. If any of the internal fuses
blows, a hazard may exist. Call your TA Instruments service representative.
The only customer-replaceable fuses are the fuses located in the fuse holder located on the back panel of
the instrument. To check or change these fuses:
1
Turn the instrument off and remove the power cord.
2
The instrument power entry module has two standard fuse holders built in. Use a flat-blade screwdriver
to remove the fuse carriers.
Figure 40
Use a screw driver to open the fuse cover and remove the fuse holder.
3
Remove old fuses and replace the fuses only with the type and rating indicated on the instrument’s rear
panel.
4
Place the fuse carrier back into the fuse holder and snap the cover in place.
NOTE
: For information on replacing the RCS fuses or for maintenance needed for the various coolers,
refer to the appropriate manual or the online help associated with the DSC instrument control software.
WARNING: Always unplug the instrument before you examine or replace the fuses.
AVERTISSEMENT: Débranchez toujours l'instrument avant d'examiner ou de remplacer les fus-
ibles.
