Date: 18.12.15
Manual to personal carriage decoder
WD-PW115, WD-PW 170, WD-PW-230, WD-
PW260, WD-PW290
Document: SW 3.0 / 01www.tec4trains.deSeite
26 from 42
Revolutionen im kleinen Maßstab
1
Set TCCS-address for T4T-train automa-
tion; in example given: 1218.
2
Set speed step for address 1218 on the
position, the wagon is located This can be,
e.g. position 1
This means, that the following commands
are valid for the first wagon behind the
locomotive
3
Activate the function key F2. When
changing the function status from 0 (OFF)
to 1 (ON), the command is sent from the
locomotive decoder to the first wagon.
With this commands you can define 8 actions for each wagon.
Maximum speed of a train set
The make of the vehicle determines the maximum speed. Freight waggons can run with a maximum
speed from 60 up to 100 km/h whereas the range of the maximum speed of passenger waggons is
much wider.
The maximum speed can be set for all coupled decoders within a train set with CV136 to CV139.
If several freight waggons are set to a maximum speed of 80 km/h for going forwards as well as
backwards, all waggons can be coupled to one locomotive and thus programmed all at the same
time, as described. To do so, successively enter the required commands, using POM (main track
programming): Here is an example for a locomotive with the driving ad-
dress 4:
Programming order for the wagon maximum speed
All vehicles, that are coupled to the locomtive, are programmed synchronous.
function
keys
measure
explenation
1
Programming CV 136 in the wagon de-
coder
release POM command:
locomotive address / CV 179 / value 0
In CV 136 the hundreds of the maximum
speed forward are written. In CV 179 of
the locomotive this value is set.
2
Programming CV 136 in the wagon de-
coder
release POM command:
lcomotive address / CV 178 / value 136
With the programming of the destination
CV in the wagon decoder, LD-1x releases
the programming process via TCCS.