T Scale AW20, Руководство по эксплуатации

Страница: 12 / 56

AW20 Series Weighing Scale Operation Manual
- 7 -
3.4 Power Connection
 Connect the adaptor pin in to the indicator adaptor jack.
 Adaptor jack is locating bottom of the scale.
 Adaptor connects into your AC power socket. Plugable equipment must be installed near an
easily accessible socket outlet with a protective ground/ earth contact.
3.5 Rechargeable battery
（
optional
）
Note: Please charge the battery before using the scale for the first time .
 The low voltage battery symbol on the weight display indicates that the battery is getting
low. It ’ s time to charge the battery with the AC power. If scale goes on being used without
proper charging, <BAT-LOW> words will flicker on the display.

Approximately 30 minutes of instrument usage are left; afterwards it will shut off
automatically.
 Please use the supplied battery charger for charging the battery immediately,or scale
cannot be used.
3.5.1 Charging the battery

Before the first use, the battery should be charged by connecting it to the mains power
supply for at least 5 hours.
 When the scale is plugged into the mains power the internal battery will be recharged.
 Verify that the AC power socket outlet is properly protected.
 There is an battery symbol at the upper side of display to indicate the status of battery
charging.
Fully charged
Low voltage
Charging
3.5.2 Battery replacement
1 Place the indicator display down on horizontal desktop (1).
2 Open the battery cover along the arrow direction (2).
3 Take out the foam next to the battery (3).
AC Adapter Jack