FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Toyota LandCruiser 200 Series 2007+
Part No.
070SB13R82A
For further information contact T.J.M. Head Office on (07) 3865 9999. Distributors Australia
wide.
File: F-1434.docx
Page 13 of 18
11/12/2013
53.
Fit the fairlead cover plate to the FPS, using
M8 x 1.25 x 20mm hex bolts (2), M8 x
Ø19mm flat washers (4) & M8 nyloc nuts
(2).
54.
Install each fog-light's wiring harness to the
vehicle's wiring harness.
55.
Check the operation of the fog-lights, then
un-plug them.
56.
Loosely attach the fog-light angle bracket to
the fog-light (as shown), using M6 x 1.0 x
16mm hex screws (2), M6 x Ø12.5mm flat
washers (2) & M6 flange nuts (2).
The fog-lights are left & right. Ensure that the
wiring loom plug is facing the ground
57.
Attach the fog-light to the FPS (as shown),
using M6 x 1.0 x 16mm hex screws (4), M6
x Ø12.5mm flat washers (4), M6 flange nuts
(4) & a fog-light washer plate (1).
Position the fog-
light washer plate
on the inside of the
fog-light bracket.