Translation of original operating instructions
8
4.
Make sure that the mains lead and plug are in a good condition without loose ends or damage.
5.
Place the cutting machine on a flat surface to prevent instability
6.
Zero-voltage release: if the machine's power supply is interrupted for any reason, then the machine must switch
off automatically.
5.9.
Starting the tool (Fig. 10)
Before starting the stone cutting machine, pay attention to working instructions
7.1 and 7.2.
1.
Insert the mains plug into a socket with safety contact. If an extension cable
is required, please note that with an extension length of up to 20m, a cable
with a cross section of 1.5mm² must be used.
2.
Always check the functionality of the PRCD safety switch as described in
chapter 5.8 before switching on the tool.
3.
For starting the tool, press the green button marked with
“I / ON". (Abb. 10)
4.
For stopping the tool, press the red button marked with
“O /Off”. (Abb. 10)
During the cutting process, only place the workpiece on the work surface.
Never reach your hands into the area near the diamond blade during the cutting process.
Always place the workpiece up against its longitudinal and transverse stops..
5.
Execute a straight cut (90°). Adjust the depth limiting set screw (Fig. 12 / No.1) until the diamond blade reaches
approx. 5 mm below the work surface of the sled. Hold the cutting unit in this position and now turn the stop screw
for height limitation (Fig. 12 / No. 2) until the unit is secured in this position. Retract the work sled completely and
set the stop angle to reflect the desired cut length. Position the workpiece to be cut at the back of the sled and
flush with the lateral angle guide, then move the sled slowly and evenly towards to diamond blade. Avoid
overloading the drive motor by feeding the workpiece into the blade too quickly.
6.
Executing a diagonal cut: Follow the same cuts as for a straight cut but preset the corresponding angle on the.
7.
Executing 45° mitre cuts: See chapter 7.2. and Fig.13. Otherwise follow the same steps as for the straight cut.
6. Blade replacement
WARNING!
Disconnect the power supply and turn the switch on OFF
before adjusting or maintaining the tool! Never use toothed blades for
this tool.
Choice of blade
Only use diamond blades with continuous rim and recommended by the manufacturer.
For the type CSC 350-2000 PRO, the diameter of the blade needs to be 350 mm, the
bore of the blade must be 25.4 mm.
Replacing the diamond blade (Fig. 11)
1.
First remove the hose (1).
2.
Unscrew and remove the four retaining screws (2).
3.
Remove the side cover (3).
4.
Fit the hex wrench supplied to the retaining nut on the blade (4).
5.
Insert the screwdriver supplied through the hole in the shaft and hold it firmly (5)
6.
Turn nut clockwise using the hex wrench (6) supplied (anti-clockwise thread).
7.
Check that the shaft and flanges are clean and undamaged.
8.
Reinstall the blade (7) in reverse sequence. Pay attention to its direction of rota-
tion. Tighten the hex nut (4). Reinstall the side cover (3), the four retaining screws
(2) and the hose (1).
Do not apply side-pressure to the diamond blade. This can lead to damage on the blade and the risk of
personal injuries .
Содержание Cross Tools CSC 350-2000 PRO
Страница 15: ...Originalgebrauchsanweisung 13 ...
Страница 27: ...Notizen notes note notas ...
