T+A M 10, Руководство пользователя

Страница: 38 / 54

38
Back panel connections
RISQUE DE CHOC ELECTRIQUE. NE PAS ENLEVER LES VIS!
SHOCK HAZARD. DO NOT OPEN!
ACHTUNG HOCHSPANNUNG! NICHT ÖFFNEN!
HERFORD, GERMANY
M10 
+ +
Gnd
Control
Signal –
Gnd
Signal –
 
220 - 230 V~ 50 - 60 Hz 2500 W
INPUT
(Audio signal inputs)
Input (unbalanced)
Unbalanced amplifier input with an input sensitivity of
1 V
eff
.
The phono socket is connected to the output socket on
the pre-amplifier (s.
Appendix A 2 ).
Balanced I (4-pin)
(symmetrical signal inputs)
Pre-amplifier input with symmetrical output and trigger
voltage on pin 4.
The 4-pin
XLR socket must be connected to the pre-
amplifier’s 4-pin XLR output socket (see Appendix
A 1 ).
The  accessory range includes special XLR cables
with 4-pin plugs and a control wire for the trigger signal.
Balanced II (3-pin)
(symmetrical signal inputs)
Input for pre-amplifiers with symmetrical output. The
XLR socket is connected to the pre-amplifier’s XLR
output socket.
Note
:
The M10 is equipped with three variants of input socket
(Cinch, XLR symmetrical 3-pin, XLR symmetrical 4-pin).
When connecting equipment only one variant may be
selected at any one time. The inputs not used must be
left vacant.
R
LINK
Control input / output for  R
LINK
systems:
Both sockets are equivalent – one is used as input, the
other one serves as output towards other
R
LINK
devices.
Mains input
This socket is for mains connection and contains the
main fuse. The fuse should only be replaced with
another fuse rated at the values printed on the amplifier.
For correct connections refer to the sections
' INSTALLATION AND WIRING ' and ' SAFETY NOTES ' .