T+A M 10, Руководство пользователя

Страница: 35 / 54

35
Remote control of the M10
General
The M10 can be operated using the F10 remote control
handset. It receives its remote control commands via
the
R
LINK
master device (e.g. the P10 pre-amplifier).
This only works if an R
LINK
cable is connected between
the pre-amplifier and the M10 .
If the M10 is operated without an R
LINK
connection
(manual operation, or powered-on via trigger contact of
the 4-pin XLR socket), then the remote control functions
described here cannot be used.
On the following diagrams all buttons used for the
control of the
M10 are marked '     ' . All other
buttons are without function for the M10 .

 

Switching a 'V' system on and off
To switch the system on, press the     button
briefly in order to switch the pre-amplifier on. The M10
is then switched on automatically via the pre-amplifier.
To switch the system off, hold the     button
pressed in until all the devices in the 'V' system have
switched to stand-by mode.
The pre-amplifier, integrated amplifier or receiver is the
last device to switch to stand-by mode after about four
seconds.
Note:
If you have switched the machine off using the main
switch on the front panel (“OFF” position), then it can
only be switched on again using this switch , i.e. not
using the remote control system.
   
Switching the loudspeakers on and off
This button switches on or off the loudspeaker outputs
individually .
F10
