SZGH SZGH-CNC1000MDb Series, Руководство пользователя

Страница: 118 / 223

-Shenzhen Guanhong Automation Co.,Ltd.- SZGH-CNC1000MDb Series
- 105 -
(3) First cutting feed(C) in X-axis direction, Line 1 is feed with linear interpolation ;
(4) Whole linear interpolation with line 2 ;
(5) Cutting feed with increment width (K) from starting point to center until Length of
rectangle pad is (I+2E), Width of rectangle pad is (J+2E);
(6) Milling corner of rectangle
(7) Cutter rapid return to point R level in Z-axis and then rapid traverse to starting point ;
(8) Cutter rapid down to depth of unprocessed end surface & each cutting feed (W+nQ);
(9) Loop run (4)~(7) until finish outer circle rough milling surface with depth of Z point;
(10) Return to point R level ;
(11) Return to starting point in XY plane.
In outer circle fine milling cycle, the interpolation directions of the transition arc and fine
milling arc are different. The interpolation direction in the code means the one of the fine milling.
Note: 1. P, L is invalid when using G116/G117, but value of P will be remained as canned cycle.
2. When use G116/G117 is used, G codes in 01 group cannot be used, otherwise G116/G117 is replaced by
other codes in group 1.
3. Tool radius compensation: in the fixed cycle command, the tool radius compensation is ignored, the
system calls the tool radius compensation specified by the program during the tool infeed.
Example: Fine milling a rectangle pad(Length=50, Width=40, Height=50) that has been rough
milled as follows by the canned cycle code G133. (D1=5mm)
G90 G00 X0 Y0 Z50 ; Rapid positioning
G99 G133 X50 Y50 Z-50 R5 I50 J40 A100 B80 W20 Q10 K10 C20 E2 D1 F800 ;
Outer rectangle roughing
G80 X50 Y50 Z50 ; Cancel canned cycle and return from point R level
M30 ; End of program