SystemAir Topvex SoftCooler TR09-15, Инструкция по эксплуатации и обслуживанию

Страница: 18 / 24

14
| Alarms
8 Alarms
When an alarm is activated a message is displayed, the corresponding LED comes on and where necessary the alarm
relay is activated.
The alarms can be divided into three categories:
• Serious unit alarms (these stop the compressor).
• Alarms that stop one or more functions of the system.
• Other alarms (signal only or “warnings”) that do not stop any function, but rather warn the user that certain thresh-
olds have been exceeded, for example.
To monitor active alarms simply press the bell symbol and the display will show the name (or names, if there is more
than one active alarm); to scroll the list, use the arrow up/down buttons.
To reset the alarms, display them and then press again. If the alarm condition no longer exists, the alarm is reset, other-
wise it will be shown again.
Note:
With automatic reset, the system restarts operating in as, however the alarm LED and the corresponding
warning string remain active until the bell symbol is pressed at least twice.
Table 1 Alarms
Alarm
code Display description
Reset
Delay Alarm
relay Action
AL01 Clock board fault or not connected Automatic Immediate Yes Just warning
signal
AL02
Extended memory error
Automatic
Immediate
Yes Just warning
signal
AL03
Max discharge pressure
Automatic
Immediate
Yes
Off compressor
AL04 Min. suction pressure Automatic
Immediate
Yes
Off compressor
AL05
Power+ offline
Automatic 30 sec Yes
Off compressor
208768 | A003