SystemAir TControl POD glass EC, Руководство по установке и обслуживанию

Страница: 8 / 30

English
AUTO
1
22.3°C
Th 07.01.16 00:20
Header
Footer
Central value
+ 0.5 °C 21.5 °C
6 TControl POD glass EC
6. DISPLAY
6.1. MAIN DISPLAY
The main screen is divided into 3 areas: header, central value and footer.
6.2. HEADER
The header shows the time, day and date. In addition, an information symbol is available on request or for
certain states/modes. The positions are predefined and cannot be changed.
Information icon
6.3. CENTRAL VALUE
By default, the central value indicates the room temperature value measured by the thermostat’s internal
sensor.
If an external sensor is connected and the corresponding input is configured accordingly, this value will be
shown on the screen (Refer to the § MODBUS TABLES , page 22 - address 18).
Depending on the configuration ( Refer to the § MODBUS TABLES , page 22 - address 10), the screen may
display:
²
ambient temperature
²
setpoint ( )
²
setpoint offset ( )
Once the arrow is pressed, the values screen changes to show the setpoint adjustment submenu. The
screen then returns to the main screen after 3 seconds without action.
After pressing the arrows to adjust the setpoint, the main screen becomes the setpoint
adjustment screen. Pressing one of the 2 arrows again changes the value.
6.3.1. SETPOINT ADJUSTMENT
ECO mode Alarm
To adjust this setpoint, 2 options are available (Refer to the § MODBUS TABLES , page 22
- address 114):
²
adjust the value as an offset (not address 22)
²
adjust the desired temperature directly (basic value)
Offset adjustment Setpoint adjustment