- 30 -
699-41-20.1
DuoLine 80x80
2 x 2,5 cm3
DuoLine 80 x 120
2 x 2,5 cm3
DuoLine 80x120-II
2 x 2,5 cm3
DuoLine 80
2 x 2,5 cm3
DuoLine 160
2 x 5 cm3
** Grease in two stages. After the first stage, drive the guide slides
through two slide lengths and then top up with the second stage.
6.7.10.3
Lubrication points
Version
View of lubrication points
Tooth belt (Z)/without drive (K)
Spindle (S)
DuoLine Z/R/S
120x80
DuoLine Z/R/S 80x80
DuoLine Z 80x160
To achieve both lubrication points
move the guide carriage accord-
ingly
Fig. 21 View on the lubrication points for different axis types:
- for the guide shaft (3) and
- for the spindle (5).
6.7.11
Lubrication Axis type PLS-II
All linear units are provided in the factory with the required lubricant
quantities. Servicing intervals are dependent on the hours run, the stress-
ing and environmental factors.
Lubrication occurs directly via the grease nipple. Before lubricating, clean
grease and oil from the lubrication point. Ensure you align the grease gun
axially with the flow direction of the nipple.
6.7.11.1
Lubrication of the guide shafts
Lubrication of the
guide shafts
Oiled felt strips (1) are used for lubricating (cleaning) the guidance shafts.
The felt strips must be reoiled periodically, according to the stressing, via
the shaft lubrication system.
