SYSMEX XE-5000, Инструкция по эксплуатации, Страница: 191 / 262

CHAPTER 10 Troubleshooting
Sysmex XE-5000 Instructions for Use 10-11
R
e
vi
se
d A
p
ri
l 20
07
2. Temperature Errors
Error messages:
-0.07 MPa ERROR
Status:
Not Ready
Category:
Analysis Error Probable Cause
1. Inadequate vacuum in the Pneumatic Unit
2. Pressure leakage from tube or nipple
Corrective Action
1. The Pneumatic Unit is probably defective. Contact your
Sysmex technical representative.
2. Check the tube connection and nipple looseness.
Error messages:
-0.04 MPa ERROR
Status:
Not Ready
Category:
Analysis Error Probable Cause
1. -0.04 MPa vacuum adjustment error
2. There is fluid in the Pneumatic Unit trap chamber.
3. Pressure leakage from tube or nipple
Corrective Action
1. Adjust vacuum to -0.04 MPa.
(Refer to Chapter 9: 9.21 Adjusting pressure and vacuum.)
2. Drain fluid from the Pneumatic Unit trap chamber.
(Refer to Chapter 9: 9.2 Removing fluid from the Pneumatic
Unit trap chamber.)
3. Check the tube connection and nipple looseness.
Error messages:
Pressure Lower Error
Status:
Emergency Stop Probable Cause
1. Pneumatic Unit power is OFF during the operation.
2. Pressure connection tube is disconnected.
Corrective Action
1. Check the Pneumatic Unit power switch and the power cord
connection.
2. Check the pressure connection tube.
Error messages:
Close RBC Detect Cover
Status:
Not Ready Probable Cause
1. RBC detector cover is open.
2. The cover sensor of RBC detector has failed.
Corrective Action
1. Close the RBC detector cover. If the error persists, the
cover sensor is probably defective.
2. Replace the cover sensor of RBC detector:
Contact your Sysmex technical representative.
Error messages:
IMI Detector Cover Open
Status:
Not Ready Probable Cause
1. IMI detector cover is open.
2. The cover sensor of IMI detector has failed.
Corrective Action
1. Close the IMI detector cover. If the error persists, the cover
sensor is probably defective.
2. Replace the cover sensor of IMI detector:
Contact your Sysmex technical representative.