1
Syntron® PowerPulse
TM
(115/230V) WT Control
■■■■■■■■■■■■■■■■■■■■■
INSTALLATION ■ OPERATION ■ MAINTENANCE
Thank you for buying your equipment from SYNTRON. This manual will help you to understand
how your equipment operates and what is required to maintain peak performance. Please read
it thoroughly and keep it on file for reference.
Your satisfaction is important to us, so please direct any comments to our Marketing
Communications department.
Date Purchased: ______________________
Part No.: _____________________________
Serial No.: ____________________________
Factory Order No.: _____________________
INTRODUCTION
The PowerPulse 115/230V WT control regulates the vibration amplitude of feeders and vibrators through phase
control provided by a Silicon Controlled Rectifier (SCR). The printed circuit board (PCB) includes an OFF-ON
line switch, a terminal block, and an SCR assembly for converting alternating current to pulsating direct current.
It also includes a potentiometer for controlling the voltage to the equipment. An intermittent switch (C1/C2)
provides the OFF/ON switching capability typically required when the PowerPulse control is used with a flow
switch or a parts detector.
SAFETY INSTRUCTIONS
Product safety labels must remain highly visible on the equipment. Establish a
regular schedule to check visibility. If safety labels should require replacement,
contact SYNTRON Material Handling, for an additional supply free of charge.
WARNING: These instructions and safety precautions must be followed. There is
a hazard of electrical shock to the operator. NOTE: Local safety codes and
regulations must be considered when installing and/or operating this control.
© 2014 Syntron Material Handling, LLC. All rights reserved.
SM0098 090214