SYNTHR SYNTHR3, Руководство пользователя

Страница: 6 / 38

Page 6
SYNTHR3 Manuel V1.01 EN
FIRST VISIT
The SYNTHR3 consists from left to right of :

The oscillator section consists of 3 VCOs. VCOs 1 and 2 are identical except that VCO2 can synchronize with VCO1.
VCO3 does not have a PW modulation section, but has an additional waveform, it can synchronize to VCO1 as well
and above all can be transformed into an LFO (LFO1). This section is reinforced by a sub-oscillator of the VCO1
comprising 3 waveforms at octave -1 and one at octave -2.

A modulation section with a digital LFO (LFO2) comprising 16 modifiable waveforms. A Sample and Hold and a noise
generator.

An ensemble MIXER which allows to send each of the 6 available sources to the VCF1 or / and depending on the
playing modes, the VCF2.

The filter section with a low-pass VCF1 (LP) and a low-pass or multimode VCF2 *

Underneath are two envelope generators, one serving as modulation for the VCOs and LFO2, the other dedicated to
the filters.

At the bottom there is a general volume and a frequency tuning over more or less an octave.

Finally on the right are 2 VCAs with an envelope generator whose role will be specified according to the play mode.

A Ring Modulator between VCO1 and a mixer of VCO2 and VCO3.

switchable portamento for VCO1 and VCO2.
We went around the analog part and we arrive on the MIDI controller with its 4 lines screen that will allow us to control the
different playing modes, the MIDI channel if needed, the Tuning fork, to save "patches" and to activate the internal
Arpeggiator as well as the internal Sequencer. This MIDI controller has no action on the audio synthesis.