Syntec 610-E5, Руководство по эксплуатации, Страница: 27 / 129

机床产品
/Machine Tool Products
–
610-E5/610-H5 5-Axis Wood Operation Manual
Function Key and System Configuration
–
•
•
•
•
•
a.
b.
c.
d.
e.
Width J: Workpiece width in Y axis direction
Safety Distance H: When the middle function starts, the initial position will be located near the center
of workpiece, while moving from the center to the outer edge of workpiece, descending to Z axis
coordinate P2 and searching for the border, a safety distance is required to avid collision between the
measuring tool and workpiece.
Feedrate F: Detecting speed of auto middle function
Z axis Coordinate P2: This Z axis coordinate is to ensure that the measuring tool is able to contact the
border of workpiece when running auto middle function. It can be set by leading the tool to P2 and
press "Z axis position teach".
Operation method
After setting up following the descriptions, place the tool above workpiece upper surface and near
the center point, distance between the tool and the upper surface should allow the tool to move
freely and not touching the surface. The point will be the starting point of auto middle function.
Switch to auto mode and press [Start Auto Middle Function] to begin
The system will move the tool and contact the workpiece border according to the set data, the
coordinate values will be shown on the screen. X, Y coordinate of the workpiece center point will then
be calculated.
For controller software versions before 10.116.24x(included), first switch to workpiece coordinate
setting screen, then move cursor to the required workpiece coordinate system and press F3 "Aux.
Coord. Teach", the system will input the Aux. Coord. of the cursor located axis to the column.
For controller software versions above 10.116.34(included), first move cursor to "Workpiece Coord.
No. P" on middle function screen, then input the required workpiece coordinate number and press F5
"Aux. Coord. Auto Setting", the system will input the Aux. Coord. in X, Y axis direction to the
corresponding workpiece coordinate.
1.5.2 Tool Set