SynOptics SYNBIOSIS aCOLyte3, Руководство пользователя

Страница: 87 / 110

Editing plate measurements
l
Adjusting the frame for a result , page 84
l
Rejecting small particles in a result , page 84
l
Changing the Sensitivity setting for a result
, page 85
l
Splitting colonies in a result , page 85
l
Adding exclude regions to a result , page 86
l
Zeroing the count , page 87.
Editing the plate identifier, comments and dilution
To add or edit a comment and/or edit the plate identifier and/or, where relevant, edit the
dilution for a result:
1. Select the Edit Result tab for the plate result – see Editing plate measurements , page 78.
The Editing Plate panel will be displayed at the bottom of the aCOLyte3 window:
2. Edit the plate identifier in the left-hand edit box as required.
3. Add to/edit the Comments in the right-hand edit box as required.
4. To edit the dilution, where relevant:
a. Press the dilution button, for example:
to open the Dilution Editor:
b. Use the dilution boxes to enter the dilution: you can type directly into the boxes or
use the + and – buttons to increase or decrease the values.
Notes The left-hand box is the sample proportion; the right-hand box is the total, so 1:10 means one
part sample in ten parts total volume. This means that the right-hand number must not be
smaller than the left-hand number.
c. Press OK to confirm the dilution you have set and return to the Editing Plate panel.
5. Save the change to the result (see Saving changes to results , on the next page).
aCOLyte3 User Manual 81