DOC-116-121609-017-C-0
WSW-02, WSW-08, WSW-02-PS, WSW-08-PS
WARNING AND CAUTIONS:
•
TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER
AT CIRCUIT BREAKER
OR FUSE AND TEST THAT POWER IS OFF BEFORE WIRING!
•
Risk of Electric Shock:
- More than one disconnect switch may be required to de-
energize the equipment before servicing.
•
To be installed and/or used in accordance with appropriate
Electrical Codes
and
regulations.
•
If you are unsure about any part of these instructions, consult an electrician.
WARNING AND CAUTIONS:
•
Disconnect power at circuit breaker or fuse when servicing, installing or removing
the wireless switch.
•
Use this device with copper or copper clad wire only.
•
Wiring Connectors:
All existing wiring connectors must be replaced with new UL
listed wiring connectors. All wiring connectors must be correctly sized for the
application and the number and the size of the electrical conductors.
INSTALLATION GUIDE
SPECIFICATIONS
Input Power: 1.2W
Input V12V DC to +24V DC
Radio Frequency:2.4 GHz SNAP
Operating Temperature:-20 to 60 C
Operating Humidity: 10 to 90% non-condensing
Dimensions: 4.32” H x 1.63” W x 1.75”
CAUTION
•
This product must be installed in accordance with national, state, and local electrical
codes and requirements
•
All work must be performed by qualified personnel
INSTALLATION INSTRUCTIONS
WARNING: TO AVOID FIRE, SHOCK, OR DEATH: TURN OFF POWER
AT CIRCUIT
BREAKER OR FUSE AND VERIFY THAT POWER IS OFF BEFORE WIRING!
Installing the Switch
1.
Connect the switch and power supply as indicated in Figure 1.
2.
Carefully fold the wires and power supply into the junction box.
3.
Securely mount the switch to the junction box.
Mounting the Wall Plate
Included in the box is a snap on wall plate and a wall plate adaptor. See Figure 2. The
installer can use the included wall plate or a wall plate of their choice. Industrial sites
typically use a stainless-steel wall plate.
Typically, the wall plate adaptor is not needed. You should be able to snap on the wall
plate without removing the 4 ears on the switch.
1.
If the supplied snap on wall plate will not snap on the switch ears, try loosening the
screws a tad to create some space. Or add a spacer to the top and bottom screws to
create the space for the tabs to engage.
2.
If the ears on the switch prevent mounting a wall plate, then remove the ears (see
Figure 3) and install the wall plate.
Operation
1.
Once installation is complete and power is applied, BUT before the switch is
provisioned as part of a SimplySNAP system, the STATUS LED will blink blue.
2.
Once the switch is provisioned as part of a SimplySNAP system, the STATUS LED will
remain solid blue.
3.
If the wireless switch loses communication with the SimplySNAP site controller, the
switch will blink red.
4.
All of the LEDs included as part of the wireless switch can be dimmed by
simultaneously pressing any two buttons on the switch. Simultaneously press any
two buttons again to return the LEDs to full bright.
Provisioning
For information about provisioning the Wireless Switches, please refer to the
SimplySNAP User Guide at:
https://www.synapsewireless.com/
Click on Resources
Menu, then select
Lighting Resources
.
Figure 1
