Symmetricom TimeProvider 500, Руководство пользователя, Страница: 109 / 174

098-00172-000 Revision A – December, 2009 TimeProvider 500 2.0 User’s Guide 109
Chapter 4 CLI Commands
Set PTP Commands
Response:
Management for GM1 enabled
set ptp transport
This command is new for version 2.0.
This command defines the type of network used for transporting PTP traffic to
optimize performance. This command makes configuration profile changes.
Ethernet should be chosen if the entire path is over native Ethernet. For
non-Ethernet transports configured for PPS-coupled mode (see
set output
pps-mode ), time services are disabled.
Syntax:
set ptp transport {dsl|ethernet|microwave|sonet}
Range:
TP-500> set ptp transport
dsl - Sets PTP transport mode to DSL
ethernet - Sets PTP transport mode to Ethernet
microwave - Sets PTP transport mode to microwave
sonet - Sets PTP transport mode to SONET
Example:
TP-500> set ptp transport dsl
Response:
Setting PTP transport mode to DSL
set ptp unicast announce-int
This command sets the desired interval (in seconds) between announce messages
sent by the grandmaster clocks.
Syntax:
set ptp unicast announce-int a_interval
Range:
a_interval = [1 | 2 | 4 | 8] seconds
Default:
a_interval = 1 second