Symbol PTC-2124, Руководство пользователя

Страница: 57 / 114

Replacing the battery pack
PTC-2124 User’s Guide 45
The Batt LED glows to show the
recharging status. See Appendix C
for an explanation of the Batt LED
codes.
3. Charge the battery pack for 1.5 to 2.5 hours or
until the Batt LED glows solid green.
4. When charging is finished, disconnect the AC
adapter from the electrical outlet and the PTC or
disconnect the vehicle adapter from the cigarette
lighter socket and the PTC.
Charging via a communication cradle
To charge the PTC’s battery pack via the SC-1124 or
the VC-1124, simply insert the PTC into the cradle,
following the instructions provided. The PTC’s battery
pack will be recharged automatically.
Charging via a connector pod
To charge the PTC’s battery pack while a CP-1124
Connector Pod is attached to the PTC, follow the
instructions provided with the pod.
Replacing the battery pack
Always connect the AC adapter to
the PTC and an electrical outlet
before removing the PTC’s battery
pack if the Batt LED is blinking red to
avoid losing data in RAM. Use the following procedures to remove and replace
the PTC’s battery pack when necessary.
Removing the battery pack
!
Never leave the PTC without the
battery pack installed. The bridge
battery will drain in 4 to 5 hours,
and all data in RAM will be lost!
1. Suspend the PTC.
2. Press the PTC’s two battery release buttons; then,
remove the battery door.
3. Tilt the PTC and allow the pack to slide out into
your hand.
Installing a new battery pack
1. Insert the battery pack into the PTC’s battery
compartment, making sure that the battery pack’s
contacts align with the contacts inside the battery
compartment.