Symbol PDT 7200 Series, Справочное руководство, Страница: 35 / 142

3-3
Spectrum24 Network Configuration
Introduction
In order to use Symbol’s Spectrum24 wireless LAN on the terminal, the terminal must be
properly configured with the correct ESS ID and other network entries. This chapter covers
the procedures for setting up your terminal on the network.
To configure the terminal for use on the Spectrum24 wireless network:
1. Press and hold the Power button for 16 seconds to cold boot the terminal. The
Symbol splash screen displays.
2. The calibration screen displays. Calibrate the screen and accept the new calibration
values when prompted. The Program Launcher screen displays.
3. Select the Control Panel option. The Control Panel Test Program screen displays.
4. Select the S24 Configuration option. The Spectrum24 Configuration screen displays.
Figure 3-1. Spectrum24 Configuration screen
The Spectrum24 Configuration screen has the following options:
!
View Config: Displays the current Spectrum24 system information and
configuration
!
S24 System: Enables you to set some commonly used Spectrum24 system parameters
!
Signal: Displays the signal strength, roaming count and network status
!
Ping Test: Provides both ICMP ping and WNMP ping test
!
S24 Network: Allows you to define Spectrum24 network settings, such as enable
DHCP or setting IP address, subnet mask, DNS, WINS, etc
!
S24 WEP Config: Configure Wired Equivalency Protocol for Network Connection.