Symbol MiniScan MS-120X, Руководство по интеграции

Страница: 219 / 410

9-123
Parameter Menus
Intercharacter Delay
Parameter # 6Eh
The intercharacter delay gives the host system time to service its receiver and perform
other tasks between characters. Select the intercharacter delay option matching host
requirements. The delay period can range from no delay to 99 msec in 1 msec increments.
After scanning the bar code below, scan two bar codes beginning on
page 9-144 to set the
desired time-out. To change the selection or cancel an incorrect entry, scan the Cancel bar
code on page 9-146 .
Intercharacter Delay
Host Serial Response Time-out
Parameter # 9Bh
This parameter specifies how long the decoder waits for an ACK or NAK before resending.
Also, if the decoder wants to send, and the host has already been granted permission to
send, the decoder waits for the designated time-out before declaring an error.
The delay period can range from 0.0 to 9.9 seconds in 0.1 second increments. After
scanning the bar code below, scan two numeric bar codes beginning on
page 9-144 .
Time durations of less than 1.0 second require a leading zero. To change the selection
or cancel an incorrect entry, scan the
Cancel bar code on page 9-146 .
Host Serial Response Time-out