Symbol LS4000P Series, Руководство по продукции

Страница: 27 / 170

3-1
Chapter 3
Scanning
Scanning 1D Bar Codes
To scan a 1D bar code:
1. Make sure all connections are secure, and the symbol you want to scan is within the
scanning range (refer to Technical Specifications on page 4-3).
2. Aim the scanner at the symbol and press the trigger. The scanning beam remains on
for approximately 3.0 seconds (default) or until a successful decode.
The scanner has read the symbol when:
!
You hear a short, high tone beep (if the beeper is enabled).
!
The yellow LED on the rear of the scanner turns green.
The green LED stays lit for two seconds or until the next trigger pull.