Symple Height Adjustable Base
1. Turn tabletop upside down. Extend stretcher to desired length, 45" to 68", adjustable in 2" steps. The
stretcher must not be pulled completely apart in order not to pull the drive shaft apart. Minimum
adjustment in the connection end is 4" (to keep power and RJ45 connector ports accessible); otherwise
adjustable in 2" steps.
Notes
:
• This product is shipped in separate boxes. Check packaging and items for visible damage and ensure the
drive shaft is mounted correctly and not pulled apart.
• Read this manual, completely, before using this product. Failure to follow instructions and safety precau-
tions in this manual can result in property damage, serious injury, or death.
• Use with 24", 30" and 36" D surfaces to construct a height adjustable table.
•
Telescoping expandable base fits surface widths from 48" to 96".
• This product contains an automatically-reset thermal limiter which protects the unit from damage due to
heat generation. Continuous use may result in a temporary shutdown of the electric height adjustment
feature of the table base. If this occurs, please allow a cooling period of two hours before resuming normal
use. The electric height adjustment feature of this product is not intended for continuous operation. The
duty cycle is 5 % ≈ 1-minute continuous use at full load, followed by a 19-minute pause.
• Electrical rating: 120V, 60 Hz, 3 Amps
WARNING
: Do not tighten the #10-12 surface screws more than 25 in-lbs. in laminated surfaces or 40 in-lbs.
in phenolic surfaces. Silicone adhesive recommended to attach epoxy surfaces.
Product Numbers
• SWEG28J
Hardware Pack:
SWEHP (p/n 20103111-01)
Required Tools
• ³/
16
" Allen Wrench
• #2 Phillips Bit
• Cordless Drill/Driver
•
Tape Measure
Stretcher
Cantilever (x2)
Feet (x2)
Leg (x2)
INSTALLATION INSTRUCTIONS
p/n 20102501-01 rev A
SYMBIOTE.COM
sheet 1 of 8