symbios logic J21971S-0398, Руководство по установке

Страница: 54 / 86

Completing the Installation
Turn On the Power
44 MetaStor Command Module Installation Guide Revision A, March 1998
Turn On the Power
Important Note You must power up the drive modules before the command
module.
If the command module is attached to one or more
MetaStor Drive Modules, turn on the drive modules first, followed
by the command module.
Instructions
Use this procedure to turn on the power to the command module
and check the system’s status.
1
Turn on the power ( Figure 31 on page 42 ).
Turn on the power to each device as follows:
a
Main circuit breakers in the Data Center cabinet, if
applicable
b All drive modules attached to the command module
c Both power switches on the back of the command module
2 Check the command module for faults.
The command module may take from three to ten seconds to power-up.
During this time, you will see the amber and green LEDs on the
command module turn on and off intermittently.
Check the LEDs on the front and back of the command module. Under
normal start-up conditions, the green Power LEDs will be lit and the
amber Fault LEDs will be unlit. If an amber Fault LED comes on, refer
to the troubleshooting charts provided in the “MetaStor Command
Module System Guide,” J20971S.
3 Install blank panels as necessary (rackmount only).
Use the kit instructions blank panel kits
4
Go to “Configure the System” on page 45 .
If applicable, replace the front panel on the command module and
panels on the Data Center cabinet.
End of Procedure