symbios logic J21971S-0398, Руководство по установке

Страница: 30 / 86

Installing the Rackmount Command Module
Connect the Interface Cables
20 MetaStor Command Module Installation Guide Revision A, March 1998
Caution Bending or damaging Fiber Channel cables could result in
degraded performance or data loss.
Make sure the cables are not
pinched, bent, nicked, or pulled during the installation.
Caution Fibre optic cables are very fragile.
●
Do not pinch the cables with tie wraps.
●
Do not make sharp bends when routing the cables (see Figure 9 ).
●
Do not step on the cables or locate them in aisles or walkways.
3 Route the Fiber Channel cables ( Figure 9 ).
On the back of the command module, find the opening in the rear shield
around the battery harness connector (lower right corner on a
rackmount unit, upper right corner on a deskside unit). Take one of the
Fiber Channel cables and push one end through this opening. From the
front, gently pull the cable through the unit until approximately one
foot of cable extends out the front of the controller slot. Secure the cable
in the cable clips. Route the second cable in the same way.