Symantec NetBackup 5230, Руководство по установке, Страница: 24 / 60

About hardware installation
Warning: NetBackup equipment and containers can weigh in excess of 70 lbs (31.75
kg). Improper handling can result in injury or equipment damage. Use appropriate
techniques, tools, and materials when handling NetBackup equipment.
The hardware installation flow is as follows:
■
Understand the NetBackup Appliance and the Symantec Storage Shelf.
■
Check safety precautions.
■
Check installation requirements.
The rack rails that are provided for the appliance are extensible to 31.5”
(800mm). The part number of these rails is AXXPRAIL. This distance is the
maximum depth that is allowed between rack posts. If the distance between
rack posts is longer than 31.5” (800mm) the rails and the appliance cannot be
properly installed. Other rails may have different lengths. The width of the
appliance is 19” (482.6mm).
The rack rails that are provided for the Symantec Storage Shelf are extensible
to 36” (914mm). This distance is the maximum depth that is allowed between
rack posts. If the distance between rack posts is longer than 36” (914mm) the
rails and the appliance cannot be properly installed. The width of the storage
shelf is 19” (482.6mm).
■
Unpack the devices.
■
Install rack rails in the equipment racks for the NetBackup Appliance and
Symantec Storage Shelf. The storage shelf is heavier than the appliance. All
storage shelves should be installed at the bottom of the rack, below the
appliance.
■
Install the NetBackup Appliance and Symantec Storage Shelf into the rack
rails. The appliance height is two rack units (RU) and the storage shelf height
is 3RU.
■
Screws are provided with the hardware as needed. Insert the screws into the
rack. Use the screws in back and in front to secure the devices to the rack.
■
If your appliance rails have built-in pins instead of screws, secure the pins in
the rack holes. The blue pin indicates the bottom of the rail.
■
Connect the two SAS cables between the appliance and the Symantec Storage
Shelf that is closest to the appliance.
■
Plug the two power cables which are provided for each device into appropriate
AC power supplies.
Preparing for hardware installation
About hardware installation
24