Symantec NetBackup 5220, Руководство по устранению неисправностей оборудования

Страница: 136 / 169

136 Chapter 7
Symantec Storage Shelf hardware removal and replacement
Installing the Symantec Storage Shelf guide rails
 Symantec Storage Shelf (qty 1)
 RJ11-to-DB9 serial data cables (qty 2)
 Dual-controller models, (qty 2)
 Left and right rack mounting rails (1 each)
 1.5m (4.9 ft) Power cords (qty 2)
Installing the Symantec Storage Shelf guide rails
Each left and right mounting rail for the Symantec Storage Shelf is shipped as a unit.
The front and back of each rail slide apart a few inches to allow for precise fitting
into the rack cabinet.
The bottom of each rail includes a sturdy metal ledge on which the Symantec
Storage Shelf sits.
Procedure
1. Obtain the left and right mounting rails. The front of these rails mount on the
front of the vertical metal posts of the rack cabinet.
2. Facing the rack cabinet, align the left rail over the vertical metal post on the left
side of the rack. Be sure that the support ledge is on the bottom of the rail,
inside the cabinet, so that the storage shelf can sit upon it.
3. Place the alignment pin in the top hole of the rail. Make sure it passes through
the rack and fasten the back of the pin.
4. Use a standard rack screw in the bottom hole of the rail, to secure the rail to the
rack.
5. Slide the rear of the mounting rail into the rear metal post of the rack.
6. Repeat these steps for the mounting rail on the right side of the rack, again be
sure that the support ledge is on the bottom of the rail, inside the cabinet.
Installing the Symantec Storage Shelf into a rack
Verify that the left and right mounting rails are installed successfully.