Symantec NetBackup 5220, Руководство по устранению неисправностей оборудования

Страница: 134 / 169

134 Chapter 6
NetBackup 5220 hardware removal and replacement
Installing and removing the rack handles
Installing and removing the rack handles
Rack handles are located on the left and right sides of the NetBackup 5220 front
panel. The handles prevent the device from sliding out of the rack and allow
attachment of the bezels.
Rack handles
1. Place the NetBackup 5220 on a grounded surface.
2. Align the the left and right rack handles with the two holes on each side of
the device.
3. Secure the two screws to the device.
4. Install the device into the rack via the rack rails.
5. When the device is firmly placed in the rack, the rack handles snap into
place.
6. To remove the rack handles, remove the device from the rack.
7. Unscrew the two screws attached to each rack handle on either side of the
device.
Installing and removing the bezel
The black, molded plastic bezel prevents damage or inadvertent contact with the
front panel of the NetBackup 5220. The bezel also allows optimal air flow from the
front of the device.
1.
Align the sides of the bezel with the front panel of the NetBackup 5220.
2. Carefully snap the bezel onto the front panel.
3. To remove the bezel, disengage it from the front panel, being careful not to
disconnect the control panel in the top right-hand corner.