Symantec netbackup 5030, Руководство по устранению неисправностей, Страница: 20 / 69

Table 3-1
Appliance LED panel (continued)
Description Label
NIC3 activity LED 6
Not used 7
NIC1 activity LED 8
NIC2 activity LED 9
Appliance status LED 10
See “About the appliance control panel” on page 33.
About the NetBackup 5030 Appliance rear panel
The NetBackup 5030 Appliance rear panel provides access to the communication
ports and the hot-swappable power supplies. How the appliance is provisioned
and configured at the factory determines the number and type of communication
ports available on an appliance. This section provides the information about the
rear panel of different appliance configurations.
NetBackup 5030 Appliances are shipped in either of two configurations: without
Fibre Channel (FC) cards or with Fibre Channel cards. Both configurations contain
a single RAID controller card that is installed in PCIe slot 1. The SAS ports on the
RAID controller are used to connect to the Symantec Storage Shelf.
The second NetBackup 5030 Appliance configuration also contains FC HBA cards
that are installed in PCIe slots 2 and 5. You can use the FC HBA cards to connect
to Fibre Transport data transfer clients or other devices.
Figure 3-6 shows the rear panel of a NetBackup 5030 Appliance without FC HBA
cards installed. Figure 3-7 shows the rear panel of a NetBackup 5030 Appliance
with FC HBA cards installed. Table 3-2 identifies the ports that are shown in both
figures.
Understanding the NetBackup Appliance
About the NetBackup 5030 Appliance rear panel
20